RE: No Outputs (Mistubishi Q-Series/GX Works2). It's worth noting that this software was maybe not from GX Works2 originally, are there usually 'change over' issues? If yes, how could we get around it?Īny help appreciated. I then forced several outputs on in the plc, no output lights illuminated on the output cards.Īny suggestions to why we're not getting any outputs? I spent a good 4 hours going through the PLC parameters tabs, ensuring cards to rack set ups are correct etc etc At this point, I checked the +24v on the cards, 24 was present. Going back to the panel, I followed solenoid cable back to output and noticed no outputs were illuminated. There is a solendoid switch on the manifold which comes directly from an output of the PLC. When digging a bit deeper, there was no compressed air to the valves. This was working as expected, but not all cylinders were going to home. Looking at the software, the 'reset' button held for 5 sec would switch on a 'go home' marker. You could see inputs switching as buttons were pressed. Contact a Mitsubishi Electric representative about GX Configurator-DP GX Works2, Version 1.600A or later GX Works3, Version 1.072A or later GX Developer, Version 8.507D or later MELSOFT Navigator, Version 2.78G or later- Begin Update C Part 4 of 5 -MELFA-Works, Version 4. I re-loaded the software and got it to monitor. GX Configurator-DP, Version 7.15R or later. The program given to us was on GX Works 2 which we have no experience of).

The information of arguments are also shown to reduce errors during.

The PLC is question was a Mitsi Q-series. Also, programs written by GX Works2 to the programmable controller can be read using. I'm no PLC expert, still learning, have experience on GX developer and Mitsi PLC's. We've managed to source the software and I was supposed to re-load yesterday. They have a fairly old machine that PLC's battery died and they lost the software.

Our firm has a section of our machines subbed out to another company.

Gx works 2 parameter